The Floor Scrubber Battery 24V 100Ah is a 25.6-volt LiFePO4 pack of 2,560 watt-hours with a 100-amp continuous rating, rated IP54, dimensioned to drop into the lead battery compartment. It powers ride-on scrubbers and cleaning robots.
Ride-On Duty
A full shift on one charge
A ride-on scrubber with a wide deck and a heavier drive uses 1 to 2 kilowatt-hours an hour. 2,560 watt-hours cover a shift of that, and a cleaning contractor finishes a site without the machine slowing through the last hour as a lead pack fades.
Two-Hour Charge
Turning between shifts
The pack takes a full charge in about two hours. A contractor cleaning two buildings a night charges between them rather than carrying a second machine, and a partial charge over a break costs the pack nothing.
Weight
Twenty-one kilograms on a ride-on
A ride-on scrubber carries its battery under the seat. Replacing a lead set of 60 kilograms with this pack takes load off the drive motor and the castors, and a contractor lifting the machine into a van feels the difference at both ends of the shift.
Data
Datasheet
| Model | CL24-100 |
|---|---|
| Nominal voltage | 25.6V |
| Capacity | 100Ah |
| Energy | 2560Wh |
| Charge voltage | 29.2V |
| Continuous discharge | 100A |
| Peak discharge | 200A (5s) |
| Cycle life | ≥3,000 cycles @80% DOD |
| Weight | ≈21 kg |
| Housing | Lead compartment fit |
| Operating temperature | Discharge -10~60°C / Charge 0~45°C |
| Protection rating | IP54 |
| Certification | UN38.3 / CE |
Fit
Ordering and charging
Send the machine model to confirm the compartment. Charge at 29.2 volts from an industrial lithium charger, or from the on-board unit switched to LFP. The two-hour charge suits a contractor working two sites in a night.
Reviews
There are no reviews yet.